Rane ECS Hardware (ECB 62e and ECM 82e) Uživatelský manuál stáhnout pdf (Strana 1)

HW Manual-1

ECS HARDWARE MANUAL ECS

ENGINEERED CONFERENCE SYSTEMS

Quick Start

The ECS Operating Manuals are split into two booklets

— one for ECS hardware and one for RaneWare® software.

Neither booklet includes service information. Should any

unit require repair, contact the Rane factory. Telephone, fax

and web info is on the rear of this manual.

Typically, only one ECM 82eA (with AEC) is required

per system. If your system requires more than eight mics,

you can add up to five ECM 82e Mixers (without AEC) for

a total of 48 mics. The QuickAdapt™ algorithm allows a

single AEC to operate the entire system. When using a

single AEC with multiple mixers, daisy-chain the ECM 82e

Mixers together using MIX OUT to MIX IN. The last mixer

in the chain and the one that connects to the MIX 1 input on

the ECB 62e must be the ECM 82eA. Only the ECM 82eA

requires its AEC Reference input to be connected to the

Mono output on the ECB 62e. See RW Manual-17.

Plain Old Telephone Service (POTS) type teleconfer-

encing, also know as phone add-on, requires an additional

Digital Hybrid. The Rane ECM 64e Conference System

with its DH 1e Digital Hybrid module can be added to

provide phone add-on support to the ECB 62e. If remote

diagnostics is desired, then add a Rane RPD 1 Programming

& Diagnostics unit or the Rane Via 10 Ethernet Bridge.

Since ECS is a programmable audio system, it must first

be programmed before it can pass audio. When power is

first applied to the ECB 62e, memory is set with all outputs

muted. For a typical system configuration, recall Memory 1

and inputs will be routed to outputs. To further simplify this

process, just recall Memory 16 and you are ready to adjust

mic levels. See RW Manual-21 for system setup procedures.

For more information there are four system applications in

the RaneWare Operators Manual.

Most echo problems are caused by improper microphone

placement and gain. To achieve good AEC performance, the

microphones must be properly set up, as shown on page

RW Manual-19 (in the ECS RaneWare Manual).

ECS Hardware Manual

This manual begins by explaining the options and

internal settings for each unit, since all optional accessories

must be installed and all internal jumpers set before

installation of the units into equipment racks. Next are

detailed descriptions of the front and rear panel features,

followed by detailed block diagrams and discussions, as

well as diagrams showing the signal flow making up the

critical “offsets,” or thresholds used by ECS. Then comes

instructions on Power, Audio & Data Connections, as well

as how to set each unit’s Device Address. Complete

electronic and mechanical specifications are found in the

Data Sheet.

Information on installing and running the control

software is found in the second booklet: ECS RaneWare

Operators Manual.

Contents

CUSTOMIZING ECS.................................................... 2

ECB 62e BASE ............................................................. 3

ECS 62 STEREO EXPANSION MODULE ............. 6

ECM 82e MIXER .......................................................... 7

ECA 2 ECHO CANCELLER MODULE ...................10

POWER, AUDIO, AND DATA CONNECTIONS ..11

SETTING THE DEVICE ADDRESS ........................13

U.S. Patent 5,848,146 on all Rane ECS products

Windows is a registered trademark of Microsoft Corporation

RaneWare is a registered trademark of Rane Corporation

ECM 82e Mixer & Security Cover

WEAR PARTS: This product contains no wear parts.

ECB 62e Base & Security Cover

1 2 3 4 5 6 ... 13 14

Shrnutí obsahu

Strany 1 - ECS HARDWARE MANUAL ECS

HW Manual-1ECS HARDWARE MANUAL ECSENGINEERED CONFERENCE SYSTEMSQuick StartThe ECS Operating Manuals are split into two booklets— one for ECS hardware

Strany 2 - CUSTOMIZING ECS

HW Manual-10Warning: Proper static discharge measures must befollowed when installing or configuring this card.Figure 11. ECA 2 Installation with ECM

Strany 3 - ECB 62e BASE

HW Manual-11POWER, AUDIO, & DATA CONNECTIONSPOWERThe Rane RS 3 Power Supply is provided with eachECB 62e Base, and required for operation of the E

Strany 4 - HW Manual-4

HW Manual-12AMX AX 232 to ECB 62e - Euroblock to DB-9 malePC to ECB 62e - DB-25 female to DB-9 malePC to ECB 62e - DB-9 female to DB-9 maleUnbalanced

Strany 5 - ECB 62e Installation Notes

HW Manual-13SETTING THE DEVICE ADDRESSThe Device Address is set using a binary code which may be determined using the followingtable, our Windows Addr

Strany 6 - HW Manual-6

HW Manual-14104807©Rane Corporation 10802 47th Ave. W., Mukilteo WA 98275-5098 TEL (425)355-6000 FAX (425)347-7757 WEB http://www.rane.comFCC NOT

Strany 7 - ECM 82e MIXER

HW Manual-2CUSTOMIZING ECSBefore installing ECS components, there are a few optionsthat need to be determined first. All but one of these requireremov

Strany 8 - ECM 82e Installation Notes

HW Manual-3ECB 62e BASEFigure 2. ECB 62e Audio Bridge Figure 3. Port 1 Selection and ControlTHE BASEThe ECB 62e Base is the master controller of the E

Strany 9 - HW Manual-9

HW Manual-4ECB 62e Base - Front Panel Description INPUT SIG level indicator: Lights when the Input signal on any Port, before trim, is above -25 dBu.

Strany 10 - HW Manual-10

HW Manual-5ECB 62e Base - Rear Panel Description PORT 1 MIXER INPUTS: MIX 1 thru MIX 6 connect to the MIX OUTs of the ECM 82e Mixers via the 12-pinEu

Strany 11 - HW Manual-11

HW Manual-6DESCRIPTIONThe ECS 62 is a plug-in module for the ECB 62e Base.Once installed, the Base can accommodate both stereo andmono audio. Included

Strany 12 - HW Manual-12

HW Manual-7QuickAdapt™The QuickAdapt algorithm allows a single AEC to operatethe entire system. This algorithm uses the Rane exclusiveSmart Last On™ f

Strany 13 - HW Manual-13

HW Manual-8ECM 82e Mixer - Front Panel Description INPUT SIG indicator: Lights when any Input signal, before trim, is above -25 dBu. Use to check sig

Strany 14 - HW Manual-14

HW Manual-9ECM 82e Mixer - Rear Panel DescriptionAn invalid Device Address set on the Mixer causesits COM LED to continually flash. The ECM 82e’spower

Komentáře k této Příručce

Žádné komentáře

Rane ECS Hardware (ECB 62e and ECM 82e) Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Audio Rane ECS Hardware (ECB 62e and ECM 82e). Rane ECS Hardware (ECB 62e and ECM 82e) User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Rane ECS Hardware (ECB 62e and ECM 82e) Uživatelský manuál Strana 1

Procházejte online nebo si stáhněte Uživatelský manuál pro Audio Rane ECS Hardware (ECB 62e and ECM 82e). Rane ECS Hardware (ECB 62e and ECM 82e) User Manual Uživatelská příručka

Shrnutí obsahu

Komentáře k této Příručce

Související produkty a manuály pro Audio Rane ECS Hardware (ECB 62e and ECM 82e)