Rane MP 44 Uživatelský manuál stáhnout pdf (Strana 20)

Lower the lever arm so the needle rests gently in the groove.9.

When the track is over, gently raise the needle off of the record using the lever arm.10.

Place the needle arm over its rest.11.

Lower it with the level arm.12.

Clip it securely in place.13.

Press the “Stop/Start” button to stop the record.14.

Lift the record off the table.15.

Replace the disc if using 45 rpm records.16.

Turn off the power dial.17.

Replace the cover.18.

Adjusting the pitch:

Look for a green light on the side of the slider on the right side of the turntable.1.

NOTE: If you see a light press the small grey button labeled “Reset” underneath the

slider. The light should disappear.

Select the range, either 8% or 16%, of pitch by pressing the “±8/±16” to the left of the “Reset” button.2.

NOTE: A scale running from +8 to -8 will appear next to the slide when 8% is activated

and a scale running from +16 to -16 will appear next to the slide when 16% is activated.

Slide the slider up to for higher pitch or slide it down for lower pitch.3.

To reset the pitch, press the “Reset” button to lock the pitch to its default.4.

Pioneer CMX-3000

The Pioneer CMX-3000 is a dual deck CD player designed to accurately sync and cue songs. They can

play either normal audio or MP3 CDs. It is the most commonly used CD player in the studio and has the most

options for advanced mixing. The player includes the capacity for multiple cue points, readouts for ID3 tags,

BPM displays, variable track length and progress displays, tempo adjusts and pitch adjusts.

The left player is run through source B on the Rane mixer’s channel 2. The right player is run through

source B on the mixer’s channel 2. The player runs through the CD3 channel on the Logitek Numix board,

making the player the best option for anyone wishing to manual mix tracks.

Common Tasks

Cuing and playing a track:

Insert a CD into one of the two slots on the upper portion of the CD player.1.

Press the large green button with the symbols for play/pause to pause the CD. It will ﬂ ash when pause.2.

Use the track search buttons to select the desired track.3.

Use the search buttons and jog wheel to select the point you want the track to begin playing.4.

Press the large red button labeled “CUE,” to create a cue point.5.

When you are ready to play the track press the green button again to play the track.6.

NOTE: If you want to sample another track on the CD, you can return to the paused cue

point by pressing the “CUE” button any time the CD is playing.

Scratching:

Press the “Jog Mode” button above the wheel till “Scratch” is displayed on the read out on the side you 1.

are using.

Use the jog wheel to scratch the track as if it were a record.2.

2-4 WIKD Show and Sysem Training Manual

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 41 42

Žádné komentáře

Rane MP 44 Uživatelský manuál Strana 20